Pistorm32-Lite

From wiki.amiga.org
Revision as of 19:01, 29 January 2023 by Admin (talk | contribs) (Created page with "thumb|250px|PiStorm32-Lite for Amiga 1200 ==Introduction== This accelerator speeds up your Commodore Amiga 1200 computer by leveraging the Ra...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
PiStorm32-Lite for Amiga 1200

Introduction

This accelerator speeds up your Commodore Amiga 1200 computer by leveraging the Raspberry Pi's computational power. The Raspberry Pi plugs into the PiStorm and emulates the native 680x0 CPU at much higher performance than the original CPU.    

Hardware Installation

1 Power down the Amiga and monitor. Unplug all cables from the Amiga.


2 Anti-statically discharge yourself before handling the device. It is recommended to use an E.S.D. wrist strap for the installation process (such as Amiga Kit product code TLSASW001).


3 Turn over the Amiga and remove the plastic trap door cover by using a small coin/flat blade screw driver to gently lever open the plastic latch.


4 Align the memory expansion's 150-pin expansion connector with the gold contacts on the motherboard and push it on until fully in place. Do not push the expansion onto the motherboard's gold contact at an angle as this could bend or damage the pins in the connector. If the metal upper RF shielding is obstructing the installation of the card, then it may need to be gently bent upwards. It can also be loosened by opening the computer and loosing the securing screw.


5 Replace trap door cover, turn over, connect all cables and power on.

   


Features

   


 

Where to buy

This product can be purchased at Amiga Stores